1 Point Coincidence TOUCH Arm Test

1 Point Coincidence TOUCH Arm Test

1. Get touch connected and turned on
2. Open TOUCH Program
3. Goto "TEST"
4. Select Probe that you have on
5. Grab a piece of masking tape and put an X on it.
6. Place the piece of masking tape made in Step 5. on the Car, OR framerack, OR 2 post lift.
7. Measure center of X, Spin arm 360 degrees and Measure center of X again.
8. Repeat Step 7. four times if the coincidence is bigger than 4mm the arm needs to be calibrated.

    • Related Articles

    • Touch arm sounds like its measuring the first point but will not proceed to the next point

      Problem: cannot get the touch to go from the very first measuring point to the second, and its making the measuring sound.  Solution: Exit out of everything and make sure that TestTouch is not open in the background                   if it is then ...

    • Touch - Measuring with mechanical components removed.

      Measuring with mechanical components removed is very easy.  Read the attached document and learn how.

    • Touch Arm isnt connecting

      Problem: Touch Arm isnt connecting to laptop Solution: 1. Check COM port 2. Check BT Key Light 3. Check BT USB Cord 4. Run TestTouch as Admin 5. Reset Touch.InI 6. Try connecting laptop to other touch, if it worked than the problem is the Bluetooth ...

    • Touch is giving random readings

      Problem: Touch Arm is giving random readings Solution: Test the arm (via Check arm coincendence)

    • Arm wont align to vehicle

      Problem: Arm wont align to vehicle Solution: 1. Make sure correct vehicle is selected (Check wheelbases just to be sure) 2. Check coincendence 3. Try 3 point alignment 4. Point to point measure alignment points